Be wary of cut corners and shoddy water bottles in the market!(two)
The editor has come into contact with a plastic water cup produced by a peer company, which uses tritan material. However, after material analysis, it was found that the ratio of old and new materials used reached 1:6, that is, the cost of new materials for the same 7 tons of materials was 38,500 yuan, while the cost of mixed materials was only 8,500 yuan. Therefore, the normal production cost of the water cup is about 30 yuan, and the cost will be reduced by at least 70% after using the mixture. About how to identify the material of the newly purchased water cup, I have shared it in the previous article. Friends who want to know, please read the article published by the editor.
Type C water cup, this is shared by a reader friend. The other party bought a branded water cup, which has better quality and material guarantee than other non-branded water cups. However, after using it for less than a month, the water cup was accidentally broken, and a crack was dropped at the mouth of the stainless steel cup body. This friend didn't notice it at first, until when this friend poured hot water into this water cup, he found that as the hot water stayed in the water cup for a longer time, black liquid kept coming out from the cracks in the mouth of the cup. This friend was frightened in an instant, so the other party told the editor about this, please explain the reason for this, and what is the black liquid flowing out?Obviously this cup is a cup of jerry-built water cups. First of all, the welding of the cup mouth is not good enough, and the stainless steel water cup will be tested when it is produced or before it leaves the factory.
One of the internal uses of the test is to allow the appearance of the water cup to be deformed, but the welding position is not allowed to be damaged.Failure to weld is a phenomenon of cheating. Secondly, black liquid came out from the inside of the water cup, indicating that this water cup was not tested to control the dryness when it was cleaned during the production process, and then proceeded to the next process, and it was not tested and cleaned. The normal procedure is that the water cup should be ultrasonically cleaned to thoroughly clean the remaining oil stains, metal shavings, etc. on the water cup, and then dried and left to stand, and the water cup should be left standing upside down for more than 2 hours before entering the next production process.
There are many ways to cut corners and shoddy water glasses in the market, and the editor will reveal them one by one in the next few articles.
Dongguan Zhanyi Commodity Technology Co., Ltd. specializes in the production of metal cups, plastic cups, coffee cups, suction mug, lunch boxes, food jar, travel mugs, portable water bottles, sports bottles, home life desktop trash cans, thermos bottles, etc.These products are all our annual exports, and are recognized and loved by the US, Europe, Australia, Japan, South Korea, Taiwan, Hong Kong and other consumers. Support for small quantity order, fast customization.
