Is the FDA or LFGB testing for detailed analysis and testing of product material components?

Is the FDA or LFGB testing for detailed analysis and testing of product material components?

Answer: To be precise, FDA or LFGB testing is more than just analysis and testing of product material components.

We have to answer this question from two points. FDA or LFGB testing is not a content percentage analysis for the material of the product. It is not that the percentages of various elements in these materials can be known through these tests. FDA testing and LFGB testing are not material composition analysis laboratories, nor are they R&D laboratories for the production of new synthetic materials. The purpose of FDA and LFGB testing is to test whether each material of the product meets the food safety requirements of the established market.

From another point of view, the FDA or LFGB inspection is not only the inspection of the material of the product storage part, but also the food safety inspection of the printing material and the spraying material. Take the stainless steel water cup as an example.

Usually the cup lid is composed of stainless steel and plastic material PP, and the cup body is stainless steel. However, the surface of the cup body is mostly sprayed, and some patterns are printed on the sprayed cup. But on the water cup, not only the accessories and materials need to be tested, but the spraying materials and printing materials also need to be tested to see if they can pass food-grade testing.

FDA or LFGB testing is a standard that has regional requirements for food-grade products.

The tested product materials will be compared and tested against the content that has been set in the standard, and the parts that exceed the standard will not be tested if there is no special requirement.

The thermos cup produced by Dongguan Zhanyi Commodity Technology Co., Ltd. uses sufficient materials and exquisite workmanship. In terms of material, we insist on using food-grade 304 stainless steel inside and outside, or a combination of 304 stainless steel outside and 316 stainless steel. The heat preservation time can reach 8 hours, and the cold preservation time can reach 12 hours. We insist on using the AQL1.0 inspection standard, which is far higher than the peer standards, and all links adopt a full inspection system to ensure that each product is a high-quality product. Customers from all over the world are welcome to visit our factory for inspection, and welcome to place orders for cooperation.