Can the vacuum-plated products only have high-gloss effects?

Can the surface of the product processed by vacuum plating only have a high-gloss effect?

Answer: No.

With the improvement of global environmental protection requirements, the traditional electroplating process is gradually replaced by new processes due to environmental pollution, and the vacuum plating process is one of its new processes. The vacuum plating process is to process the surface of the product into a metallic luster through a vacuum high-temperature process. The final effect is very similar to that of traditional electroplating. The quality of the process is much better than that of traditional electroplating, but the cost is higher than that of electroplating.

Usually when people think of the electroplating process, they will think that the product is very bright after electroplating. Whether it is gold or silver electroplating, it is as smooth and reflective as a mirror. Is it the same for vacuum plating?

In fact, it is not. The products produced by the vacuum plating process can finally achieve different effects of high gloss, semi-high gloss and matte, which are mainly determined by different paints in the later stage. The vacuum-plated base blank is high-gloss silver. In the later stage, you can spray different colors of paint to achieve toning, and then spray different effects of protective oil to finally show a high-gloss, semi-high-gloss or matte effect.

The coating of the vacuum-plated base blank is soft and easy to produce scratches. In the later stage, it needs to be protected by spraying high-hardness protective oil to increase the hardness of the surface coating and enhance the ability to resist scratches. The vacuum plating process is suitable for a variety of materials, including plastic materials PP/ABS, etc., but also suitable for stainless steel materials and aluminum materials.

The thermos cup produced by Dongguan Zhanyi Commodity Technology Co., Ltd. uses sufficient materials and exquisite workmanship. In terms of material, we insist on using food-grade 304 stainless steel inside and outside, or a combination of 304 stainless steel outside and 316 stainless steel. The heat preservation time can reach 8 hours, and the cold preservation time can reach 12 hours. We insist on using the AQL1.0 inspection standard, which is far higher than the peer standards, and all links adopt a full inspection system to ensure that each product is a high-quality product. Customers from all over the world are welcome to visit our factory for inspection, and welcome to place orders for cooperation.